Filter
Top Products
61
Troubleshooting
RFID Error Codes and Messages
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
0102
OPCODE UNAVAIL The opCode received by the RFID reader is invalid or not
supported with the current version of reader firmware.
1. Make sure you download the appropriate version of reader
firmware.
2. Turn the printer power off (
O). Wait ten seconds, and then
turn the printer power on (
I).
If the problem persists, contact Technical Support.
0055
OVERWRITE EPC Error trying to overwrite a valid EPC code.
Internal problem with the reader. If the problem persists, contact
Technical Support.
F004
POWER SELECT ERR The printer could not verify that the intended power setting has
been set successfully. If the problem persists, contact Technical
Support.
0103
POWER TOO HI The RFID reader received a command to set the read or write
power to a level that is higher than the RFID reader supports.
Check the versions of the reader firmware and printer firmware.
You may need to download different versions.
0106
POWER TOO LOW The RFID reader received a command to set the read or write
power to a level that is lower than the RFID reader supports.
Check the versions of the reader firmware and printer firmware.
You may need to download different versions.
0022
RAM ERROR Internal problem with the reader. If the problem persists, contact
Technical Support.
1234
RDR COM TIMEOUT The printer was not able to communicate with the reader. If the
problem persists, contact Technical Support.
F002
RDR COM TIMEOUT The printer was not able to communicate with the reader. If the
problem persists, contact Technical Support.
— RDR ERR
xxxx
Internal problem with the reader. If the problem persists, contact
Technical Support.
8505
READ AFI ERR There was an error reading the AFI byte.
Verify that the tag that you are using supports this feature. If the
problem persists, contact Technical Support.
8102
READ DATA ERR This can occur when one of a number of RFID operations fails.
Check that the tag is good, and repeat the process with another
RFID label. If the problem persists, contact Technical Support.
8507
READ DSFID ERR There was an error reading the DSFID byte.
Verify that the tag that you are using supports this feature. If the
problem persists, contact Technical Support.
8406
READ FILE ERR Internal problem with the reader. If the problem persists, contact
Technical Support.
Table 6 • RFID Error and Status Message Definitions (Continued)
Error
Code
RFID Error or
Status Message
Description/Action Required