Filter
Top Products
RFID Applicator Signals
Applicator Interface Connector Pin Configuration
156
58978L-008 Rev. A RFID Programming Guide 11/14/2008
Jumper Configurations and Pinouts for +5 V I/O Operation
Jumpers are used to produce isolated or non-isolated modes of operation for applicator input
and output control signals. RPAX4 printers use J4 and J5 while RXi printers user JP1 and JP2.
J4/JP1 configures the +5 V source for the optoisolator circuits, and J5/JP2 configures the
ground. For proper operation, when J4/JP1 is installed, J5/JP2 must be installed, and when
J4/JP1 is removed, J5/JP2 must be removed.
Table 13 describes the pin and jumper configurations for +5 V I/O operation.
Table 13 • Non-Isolated and Isolated Modes for +5V Operation
Non-Isolated (Jumpers In) Isolated (Jumpers Out)
Pin 1 Ground +5V, Jumper J5/JP2 In
I/O ground is connected to the printer signal
ground.
External Ground +5V, Jumper J5/JP2 Out
I/O ground is disconnected from the printer
signal ground. Ground must be provided
externally to this pin.
Pin 2 +5V Output, Jumper J4/JP1 In
+5 V I/O is connected to the applicator
interface circuit +5 V Supply.
External +5V Input, Jumper J4/JP1 Out
+5 V I/O is disconnected from the applicator
interface circuit +5 V Supply. The +5 V for the
applicator interface optoisolator circuits must be
provided externally. This input also supplies
voltage for output signal pull-up resistors.
Pinouts
2
3
4
5
6
7
8
9
1
10
10
11
11
12
12
13
13
14
14
15
15
+5V+5V
J4/
JP1
J5/
JP2
1A1A
+5V+5V +5V+5V
+28V+28V
+28V+28V
500 mA500 mA
2
3
4
5
6
7
8
9
1
10
10
11
11
12
12
13
13
14
14
15
15
+5V
1A
+5V
+28V
+28V
+5V
500 mA
J4/
JP1
J5/
JP2