Filter
Top Products
Troubleshooting
RFID Error Codes and Messages
62
58978L-008 Rev. A RFID Programming Guide 11/14/2008
9201
READ SYS ERR There was a problem reading a parameter from the non-volatile
memory of the reader. If the problem persists, contact Technical
Support.
0602
REPEATED ID One of the protocols is trying to add an existing tag ID to the
buffer.
Internal problem with the reader. If the problem persists, contact
Technical Support.
9102
RESET DEVICE ERR The reader was unable to successfully reset the reader. If the
problem persists, contact Technical Support.
810A
REVIVE TAG ERR If the problem persists, contact Technical Support.
0031
RF SECTION ERR Radio controller does not respond or general RF section failure.
Internal problem with the reader. If the problem persists, contact
Technical Support.
0000
RFID OK Normal operation.
0023
ROM ERROR Internal problem with the reader. If the problem persists, contact
Technical Support.
800C
R-T DATARATE ERR The reader to tag data bit rate is not supported by the reader, the
tag, or both.
0051
RX R/T FAIL Receiver tuning runtime failure.
Internal problem with the reader. If the problem persists, contact
Technical Support.
0050
RX TUNE FAIL Receiver tuning training failure.
Internal problem with the reader. If the problem persists, contact
Technical Support.
0027
RXD POWER HI RXD reflective power too high.
Check antenna or cable connection. If the problem persists,
contact Technical Support.
002A
RXD POWER MAX RXD reflective power max fault.
Internal problem with the reader. If the problem persists, contact
Technical Support.
0028
RXD WARNING RXD reflective power warning level. Occurs at –10 dBm.
Internal problem with the reader. If the problem persists, contact
Technical Support.
8503
SCAN EAS ERR The reader did not detect an EAS code in the field.
Verify that the tag that you are using supports this feature and that
the EAS bit is enabled.
8302
SELECT APPLI ERR Internal problem with the reader. If the problem persists, contact
Technical Support.
8402
SELECT FILE ERR Internal problem with the reader. If the problem persists, contact
Technical Support.
Table 6 • RFID Error and Status Message Definitions (Continued)
Error
Code
RFID Error or
Status Message
Description/Action Required