Filter
Top Products
111
ZPL II Commands for RFID
^RS
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
Supported Tag Types Table 9 shows the tag types supported by different RFID
printers/print engines and firmware versions. Depending on your country or on the firmware
version that you are using, your printer may not support all of the tag types listed. If you
specify an unsupported tag type, the printer uses the default value. If a tag type is shown as
supported but does not work with your printer, you may need to upgrade the printer’s firmware
(see http://www.zebra.com/firmware).
Table 9 • Supported Tag Types and Default Values
Printer
UHF Printers HF Printers
R110Xi
R170Xi
R110PAX4
R4Mplus
RZ400/ RZ600
RP4T
R110Xi HF
R2844-Z
Firmware Version
R60.13.X
R60.15.8Z and R60.16.4Z
R60.16.5Z and later
R62.13.X
R62.15.X and later
R63.13.X
R63.15.X and later
SP994O, SP999E, SP1027E,
SP1082E, and earlier
SP994P, SP999F, SP1027F,
SP1082F, and later
SP1056D and earlier
SP1056E and later
R53.16.X and later
all
R65.13.X
R65.15.X and later
all
Tag Type
UHF Tag Types and Options
None (no tag type specified) * * * a * * — — — — — — — — — — —
EPC Class 0 * * * a * * — — — — — — — — — — —
EPC Class 0 Plus * * * a * * — — — — — — — — — — —
EPC Class 1 64-bit * * * a * * — — — — — — — — — — —
EPC Class 1 96-bit # * * a # * — * * * — — — — — — —
UCODE EPC 1.19 * b * * a — * # * # * # * — — — — —
Impinj Class 0 Plus * * * a * * — — — — — — — — — — —
ISO 18000-06A — — — * — — * * * — — — — — — —
EPC Class 1, Generation 2 (Gen 2) * # # * # — # * # * # # #
— — —
ISO 18000-06B * * * a * * — * * * * * — — — — —
HF Tag Types and Options
Auto-detect the tag type by querying the
tag
———————— —————
— — #
Tag*It (Texas Instruments Tagit tags) — — — — — — — — — — — — —
— — *
I*code (Phillips Icode tags) — — — — — — — — — — — — — — — *
Pico Tag (Inside Technology’s) — — — — — — — — — — — — — — — *
ISO 15693 — — — — — — — — — — — — — # # *
# = Default value * = Accepted value — = Not supported
a. Requires printers with RFID hardware version M4xxx...x. This will not work with RFID hardware version M5xxx...x. For the RFID
hardware version, refer to the RFID HW VER line on your printer configuration label, or perform the RFID SLOW test (see Perform RFID
Test on page 22).
b. Requires R60.13.0.13ZD or later.