Filter
Top Products
RFID Applicator Signals
Applicator Interface Connector Pin Configuration
154
58978L-008 Rev. A RFID Programming Guide 11/14/2008
5 PAUSE Input To toggle the current Pause state, this input must be
asserted LOW for 200 milliseconds, or until the
SERVICE REQUIRED output (pin 10) changes state.
6 REPRINT Input • If the Reprint feature is enabled, this input must be
asserted LOW to cause the printer to reprint the last
label.
• If the Reprint feature is disabled, this input is ignored.
7+28V
(On PAX4 printers,
fused at 500 mA. On
Xi-series printers,
fused at 500 mA for
the 24–28V board
and fused at 2 A for
the 5V board.)
Caution • Replace
the fuse only with
one of the same
type and rating.
Power The Interface Power Supply. Supplies power to external
sensors as required.
Note • If operating with 28V signals only, pin 7
may be used to supply power to pin 2, which
creates a non-isolated mode of operation. (This is
applicable for all printers except the
110XiIIIPlus.)
8 POWER GROUND
(+28 V DC Return)
Ground The Interface Power Ground.
Note • If pin 7 is used to supply power to pin 2,
use this pin to ground pin 1. (This is applicable for
all printers except the 110XiIIIPlus.)
9 RIBBON LOW Output No function in RXi printers.
In the R110PA X 4 print engine, asserted if the Ribbon Low
feature is enabled and the amount of ribbon remaining on
the supply spool is below a specific threshold level.
• For print engines with the Ribbon Low Output
parameter, asserted HIGH or LOW depending on the
ribbon low output mode selected.
• For print engines without the Ribbon Low Output
parameter, asserted HIGH.
10 SERVICE
REQUIRED
Output Asserted LOW in the following circumstances:
• the printhead is open
• the ribbon or media is out
• the printer is paused
• an operational fault occurs
• a Resynch error occurs while the applicator Resynch
mode is set to Error mode
Table 12 • Applicator Interface Connector Pin Configuration (Continued)
Pin
No.
Signal Name Signal Type Description