Filter
Top Products
57
Troubleshooting
RFID Error Codes and Messages
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
800F
INVALID AUTH KEY The key number does not exist or is invalid for authentication with
a specific reader or tag.
010A
INVALID BAUD Internal problem with the reader. If the problem persists, contact
Technical Support.
0109
INVALID CMD The command does not exist or is invalid for the reader.
Internal problem with the reader. If the problem persists, contact
Technical Support.
9002
INVALID CMD The command does not exist or is invalid for the reader.
Internal problem with the reader. If the problem persists, contact
Technical Support.
9003
INVALID CRC Invalid CRC sent in the request to the reader. If the problem
persists, contact Technical Support.
9009
INVALID DATA LEN The length of the data specified in the request was invalid for the
command specified. If the problem persists, contact Technical
Support.
9006
INVALID FLAGS The flags specified were invalid for the command specified. If the
problem persists, contact Technical Support.
0104
INVALID FREQ The RFID reader received a command to set the frequency outside
of the supported range. If the problem persists, contact Technical
Support.
0500
INVALID FREQ The RFID reader received a command to set the frequency outside
of the supported range. If the problem persists, contact Technical
Support.
8014
INVALID KEY LEN The key length is not valid for the tag type, the command, or the
reader.
8013
INVALID KEY NO. The key number does not exist or is out of the range of valid keys.
9004
INVALID MESS LEN The number of bytes sent to the reader was invalid for the
command or for the message length passed in. If the problem
persists, contact Technical Support.
0101
INVALID OPCODE The opCode received by the RFID reader is invalid or not
supported with the current version of reader firmware. Make sure
you download the appropriate version of reader firmware. If the
problem persists, contact Technical Support.
OOOC
OOOD
INVALID PARAM The RFID reader received a valid command with an unsupported
or invalid value for one of the parameters. If the problem persists,
contact Technical Support.
0105
INVALID PARAM The RFID reader received a valid command with an unsupported
or invalid value for one of the parameters. If the problem persists,
contact Technical Support.
Table 6 • RFID Error and Status Message Definitions (Continued)
Error
Code
RFID Error or
Status Message
Description/Action Required