Filter
Top Products
95
ZPL II Commands for RFID
^RE
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
^RE
Enable/Disable E.A.S. Bit
Description Use this command to enable or disable the Electronic Article Surveillance
(E.A.S.) bit that is available in some ISO15693 tags (such as Philips). This command works
only on those ISO15693 transponders and will be ignored if the tag does not support E.A.S.
Format ^REt,r
The following table identifies the parameters for this format.
Important • This command is not supported by all printers or firmware. See Printer and
Firmware Compatibility on page 82 for the list of printers and firmware with which you can
use this command.
Parameters Details
t = Enable/disable the
E.A.S. bit in the
ISO15693
transponder
Accepted values:
N = Disable E.A.S.
Y = Enable E.A.S.
Default value: N
r = number of retries
Accepted values: 0 to 10
Default value: 0
Example • This example enables the E.A.S. bit in the transponder. It will retry the command
five times if necessary.
^XA
^REy,5
^XZ