Filter
Top Products
25
RFID Control Panel Parameters
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
View or Change RFID Write Power
This parameter displays the current value for RFID write power.
Note •
· This parameter does not appear on the R110Xi HF printer.
· On some printers, the options vary based on the reader. Check
the printer configuration label for the RFID_HW_VER line or
perform the RFID SLOW test (see Perform RFID Test
on page 22) to determine the reader type.
To change the value shown:
1. Press the left oval/MINUS (-) or the right oval/PLUS (+) to scroll
through the options.
View or Change RFID Read/Write Power
Note • This parameter appears only for the R110Xi HF printer,
which uses identical RF power settings for read and write
operations.
This parameter displays the current value for RFID power.
Default: LOW
Selections: HIGH, MEDIUM, LOW
To change the value shown:
1. Press the left oval/MINUS (-) or the right oval/PLUS (+) to scroll
through the options.
Table 2 • RFID Parameters (Page 4 of 7)
Parameter Action/Explanation
RFID WRITE PWR
16
Printer Firmware Version
Selections
Default
H, M, L 0–30
RXi R60.15.8Z and earlier X — L
R60.16.4Z X X L
R60.16.5Z and later (M4xxx…x reader) X X L
R60.16.5Z and later (M5xxx…x reader) — X 16
R4Mplus SP994P, SP999F, SP1027F, SP1056E, SP1082F,
and earlier
X—L
SP994Q, SP999G, SP1027G, SP1056F, SP1082G,
and later
XXL
R110PA X4 R62.15.8Z and earlier X — L
R62.16.4Z and later X X L
R63.15.8Z and earlier X — L
R63.16.4Z and later X X L
RZx00 all versions — X 16
RP4T all versions — X 16
RFID POWER
LOW