Filter
Top Products
RFID Control Panel Parameters
22
58978L-008 Rev. A RFID Programming Guide 11/14/2008
Table 2 • RFID Parameters (Page 1 of 7)
Parameter Action/Explanation
Select Print Mode
Print mode settings tell the printer the method of media delivery to use.
Make sure that your printer can support the selected option. Use RFID
mode when printing batches of RFID labels to increase throughput time.
Default: (R110PAX4) APPLICATOR
Default: (all other RFID printers) RFID
Selections: vary by printer
To change the value shown:
1. Press the left oval/MINUS (-) or the right oval/PLUS (+) to scroll
through the options.
Perform RFID Test
In the RFID test, the printer attempts to read and write to a transponder. In
the slow version, the printer first displays the hardware version, the reader
firmware version, and the program position. If the printer fails the test, the
control panel displays READ ERROR. No printer movement occurs with
this test.
To perform the RFID test:
1. Position an RFID label with its transponder over an RFID antenna
location. For the location of the RFID antenna on your printer, see
RFID Antenna Location on page 39.
2. Press the left oval/
MINUS (-) to select QUICK.
OR
Press the right oval/
PLUS (+) to select SLOW.
3. If necessary, press the right oval/PLUS (+) to select CONTINUE.
PRINT MODE
- RFID +
RFID TEST
QUICK SLOW