Filter
Top Products
127
ZPL II Commands for RFID
^WV
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
^WV
Verify RFID Encoding Operation
Description Use this command to enable or disable the write verify function. When write
verify is enabled, this command verifies the RFID encoding operation to ensure that the tag
about to be programmed contains the hex data “A5A5” in the first two bytes. This parameter is
not persistent (carried over from label to label).
Format ^WVe
This table identifies the parameters for this format.
Important • This command is not supported by all printers or firmware. See Printer and
Firmware Compatibility on page 82 for the list of printers and firmware with which you can
use this command.
Parameters Details
e = enable
Accepted values: Y or N
Default value: N