Filter
Top Products
ZPL II Commands for RFID
^RS
108
58978L-008 Rev. A RFID Programming Guide 11/14/2008
^RS
Set Up RFID Parameters
Description Use this command to set up RFID parameters including tag type, read/write
position of the transponder, and error handling.
Format ^RSt,p,v,n,e,a,c,s
This table identifies the parameters for this format.
Important • Use care when using this command in combination with ^RT or ^RF for
reading tag data. Problems can occur if the data read from the tag is going to be printed on the
label. Any data read from the transponder must be positioned to be printed above the
read/write position. Failure to do this will prevent read data from being printed on the label.
Parameters Details
t =tag type
Tells the printer/print engine which tag type you are using. If
you specify a tag type that is not supported by your printer or
firmware, the printer uses its default value. For the supported
tag types and defaults, see Table 9 on page 111.
UHF Printers
0 = None
1 = EPC Class 0
2 = EPC Class 0 Plus
3 = EPC Class 1 64-bit
4 = EPC Class 1 96-bit
5 = UCODE EPC 1.19
6 = Impinj Class 0 Plus
7 = ISO 18000-06A
8 = EPC Class 1, Generation 2 (Gen 2)
9 = ISO 18000-06B
HF Printers
Note • Only the R110Xi HF printer (firmware version
R65.X.X) supports the use of letters for this
parameter. All other printers use the numbers.
A or 0 = None
B or 1 = Auto detect (query tag to determine)
C or 2 = Tag*It (Texas Instruments Tagit tags)
D or 3 = I*code (Phillips Icode tags)
E or 4 = Pico Tag (Inside Technology’s)
F or 5 = ISO 15693
G or 6 = EPC tag (13.56 MHz)
H or 7 = UID Tag
I or 8 = Mifare UltraLight