Filter
Top Products
67
Troubleshooting
RFID Error Codes and Messages
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
000F
SERIAL ERROR 2 High level serial error 2.
Internal problem with the reader. If the problem persists, contact
Technical Support.
0021
TEMP ERROR Temperature sensor error.
Internal problem with the reader. If the problem persists, contact
Technical Support.
0022
RAM ERROR Internal problem with the reader. If the problem persists, contact
Technical Support.
0023
ROM ERROR Internal problem with the reader. If the problem persists, contact
Technical Support.
0024
SERIAL # ERR Serial number chip error.
Internal problem with the reader. If the problem persists, contact
Technical Support.
0025
ANT. BAD/GONE The RFID reader cannot detect the RFID antenna (coupler), or the
antenna (coupler) does not work. Contact Technical Support.
0026
BAD ANT.MUX Internal problem with the reader. Contact Technical Support.
0027
RXD POWER HI RXD reflective power too high.
Check antenna or cable connection. If the problem persists,
contact Technical Support.
0028
RXD WARNING RXD reflective power warning level. Occurs at –10 dBm.
Internal problem with the reader. If the problem persists, contact
Technical Support.
0029
LISTEN BUSY Listen before transmit; all frequencies occupied. Internal problem
with the reader. If the problem persists, contact Technical Support.
002A
RXD POWER MAX RXD reflective power max fault.
Internal problem with the reader. If the problem persists, contact
Technical Support.
002F
SELF TST ERR Self-test error.
Internal problem with the reader. If the problem persists, contact
Technical Support.
0031
RF SECTION ERR Radio controller does not respond or general RF section failure.
Internal problem with the reader. If the problem persists, contact
Technical Support.
0033
ANT FAILURE Antenna failure. Contact Technical Support.
0035
NO RF FIELD Internal problem with the reader. If the problem persists, contact
Technical Support.
Table 7 • RFID Error Code Definitions (Continued)
Error
Code
RFID Error or
Status Message
Description/Action Required