Filter
Top Products
ZPL II Commands for RFID
^RS
110
58978L-008 Rev. A RFID Programming Guide 11/14/2008
a = signals on applicator
Note • This parameter does not apply to the R2844-Z.
For the R4Mplus, this parameter applies only to
printers with firmware version SP994X (R4Mplus
European version).
When the value for parameter p (read/write position of the
transponder) is nonzero, this parameter changes the number of
start and stop print signals required for printing.
In Single mode, one start print command is required. In
Double mode, two are required, so the printer will resume
printing only after the second start print command is received.
For more information, see Timing Diagrams for RFID
on page 150.
Accepted values:
S = single signal
D = double signal (For the R110PA X 4, Double mode will
work only if the read/write position is changed
from the default of zero.)
Default value:
S
c
= certify tag with a
pre-read
Not applicable.
s = void print speed
Note • This parameter does not apply to the R2844-Z.
For the R4Mplus, this parameter applies only to
printers with firmware version SP994X (R4Mplus
European version).
If a label is voided, the speed at which “VOID” will be
printed across the label.
Accepted values: any valid print speed
Default value: the printer’s maximum print speed
Parameters Details