Filter
Top Products
89
ZPL II Commands for RFID
^MM
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
^MM
Print Mode
Description The ^MM command determines the action the printer takes after a label or
group of labels has printed.
Format ^MMa,b
This table identifies the parameters for this format:
This list identifies the different modes of operation:
• Tear-off — after printing, the label advances so the web is over the tear bar. The label,
with liner attached, can be torn off manually.
Parameters Details
a = desired mode
Accepted Values:
T = Tear-off
P = Peel-off (not available on S-300)
R = Rewind (depends on printer model)
A = Applicator (depends on printer model)
C = Cutter (depends on printer model)
D = Delayed cutter (depends on printer model)
F = RFID (not valid on the RP4T)
Default Value:
The values available for parameter
a depend on the
printer being used and whether it supports the option.
For supported RFID printers, the defaults are as follows:
A = R110PAX4 print engines
F = other RFID printers
b = prepeel select Accepted Values:
N = no
Y = yes
Default Value:
N
The command is ignored if parameters are missing or
invalid. The current value of the command remains
unchanged.