Filter
Top Products
107
Page setup
Parameters Used
09/14/2009 TTP 2000 Technical Manual P1002902-002
Manual Cut-Offset
If set to 1 and above, the auto offset is turned off and you must measure the offset from the
actual sensor position that is 25 mm before the cutter.
(ESC x n1 n2 is an obsolete command that sets n41 and n42. It is implemented for backward
compatibility with old drivers. Set parameters n41 and n42 with the
ESC & P n1 n2 command instead.)
FF (Form Feed)
Use FF to print the buffer content, go to the next top of form (black mark), and cut the paper.
n41 & n42
The actual cut position
Desired cut position
Black mark detected