Filter
Top Products
45
Programming
Software Command Syntax
09/14/2009 TTP 2000 Technical Manual P1002902-002
Executes the number of linefeeds as defined by variable n1. The length of each line feed is
determined by the default value for selected font or the line spacing setting specified by n13,
whichever is greater (refer to parameter Line Spacing on page 86).
If an <LF> has not yet been sent to convert the text buffer to the line buffer, the lines printed
by <ESC>d are copies of that line. Following this, the print position is returned to the
beginning of the line.
Prints data from the text buffer and feeds the paper to the top of the next page.
In fixed document length mode (n36 = 0) this command prints data in the text buffer and feeds
the paper to the top of next page.
In variable document length modem, <FF> advances to the minimum page length as specified
by n37 and n38. If the printout already is longer than the minimum page length, <FF> does
not feed any additional paper.
In black-mark mode, the <FF> command looks for a black mark, see <ESC>Z.
If Auto Cut (n34) is set to 1 (see Auto Cut after FF on page 88), FF effects form-feed, cut, and
eject.
Shifts the current print position to the next Tab position.
Set tab positions with parameters n15 to n30. Refer to Tab Stop on page 87.
ESC d n1
Make n Linefeeds
1B 64 n1 hex
27 100 n1 decimal
FF
Form Feed
0C hex
12 decimal
Note • Use Parameters n37 and n38 — Page Length Minimum on page 104 to define page
length.
HT
Horizontal Tabulation
09 hex
9 decimal