Filter
Top Products
Default Parameter Settings
Print Setup
96
P1002902-002 TTP 2000 Technical Manual 09/14/2009
The system parameter will control up to eight system components in the printer.
The bits specified so far are these:
Setting a bit to 1 enables the function and setting it to 0 disables it.
Sets the level at which the TOF sensor detects out of paper. The out-of-paper level may differ
from the black-mark level on label stock where the foil opacity indicates top of form.
This parameter is set automatically when you run the “Calibrating the TOF sensor procedure”
(manually or using ESC #).
57
255 Default
System
DRV
0 Min
255 Max
Bit 0 Clear presenter at reset
Bit 1 Pull detector
Bit 2 Horizontal
Bit 3 Standard BM
Note • This parameter is set automatically when you run the
“Calibrating the TOF sensor procedure” (manually or using ESC #).
Bit 4 Disable USB reconnect
Note • If reconnect is enabled, the PC will not be able to go to sleep
mode.
Important • If the function of a bit is not specified, it must always be set to 1.
Example •
<ESC>&P<57><254> Presenter will not be cleared at power ON and reset
<ESC>&P<57><253> The pull detector is disabled
<ESC>&P<57><252> The presenter will not be cleared at power ON and reset and the
pull detector is disabled
<ESC>&P<57><251> The printer is set to vertical mode, that is the retract output and the
normal output are swapped.
<ESC>&P<57><239> The printer will monitor USB heartbeat (SOF tokens), and thus try
to reconnect if they disappear.
<ESC>&P<57><255> The printer is reset to normal behavior
58
0Default
Out-of-Paper Level
0 Min
255 Max