Filter
Top Products
31
Operation
Installing a Paper Roll
09/14/2009 TTP 2000 Technical Manual P1002902-002
4. Cut the paper at a suitable angle. See Figure 20.
Figure 20 • Suitable Paper Edge for Auto Load
5. Insert the paper through the paper entry opening at the back of the printer.
The printer will now feed, cut and eject a printout, and then automatically go on-line.
Figure 21 • Insert the New Paper
Important • The paper sensor for 58 mm and 60 mm paper is at the same side as the interface
connector, while the sensor for 80 mm and 82.5 mm paper is on the power connector side. If
the paper is cut in a direction opposite to that as shown in the figure above, the sensor will not
detect the paper.
90º
Thermal side (top)
Cut off at
a 85º-95º
angle