Filter
Top Products
87
Default Parameter Settings
Print Setup
09/14/2009 TTP 2000 Technical Manual P1002902-002
Stores 16 different TAB stop positions. The position is set in increments of 2.5 mm.
Tab position 255 sets a tab stop on the last position of the line. Use this if you want underline
or reversed text to extend across the full paper width.
To set all tab stops at once, follow the procedure Set several parameters at once on page 61.
To move a single tab stop, use the set parameter command <ESC>&P.
Default positions are one TAB on each cm; that is parameter values 4, 8, 12 etc.
Sets the speed at which the paper is ejected / retracted.
1 = 10 steps/s, so the default 180 means 1800 steps/s. Do not exceed the default setting, as this
may cause the motor to stall.
To print in cold weather conditions, please measure the temperature inside the kiosk and set
the speed according to the temperature:
15 to 30
-Default
Tab Stop
1 Min
255 Max
Example •
<ESC>&P<15><10> Set the first tab stop 25 mm from the left margin.
31
180 Default
Presenter Speed
1 Min
255 Max
Temperature n8 n31
–10°C 19 150
–15°C 19 140
–20°C 19 120
–30°C 11 70
Note • These readings are just guidelines based on the motor specifications; there is no
guarantee that the printer will operate at the indicated temperatures.