Filter
Top Products
114 en | Configuring the AutoDome Junior HD AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
– Modem
Target bit rate: 20 kbps
Maximum bit rate: 22 kbps
Encoding interval: 15.00 ips
– GSM
Target bit rate: 7 kbps
Maximum bit rate: 8 kbps
Encoding interval: 7.50 ips
12.5 Basic Mode: Audio
You can set the gain of the audio signals to suit your specific
requirements. The current video image is shown in the small
window next to the slide controls to help you check the audio
source and improve assignments. Your changes are effective
immediately.
If you connect via Web browser, you must activate the audio
transmission on the Livepage Functions page (see
Section 11.5 The Livepage, page 95). For other connections, the
transmission depends on the audio settings of the respective
system.
Audio
The audio signals are sent in a separate data stream parallel to
the video data, and so increase the network load. The audio
data are encoded according to G.711 and require an additional
bandwidth of approx. 80 kbps for each connection. If you do
not want any audio data to be transmitted, select Off.
Line In
You can set the line input gain. Make sure that the display does
not go beyond the green zone during modulation.