Filter
Top Products
68 en | Installing a Pipe Mount AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
2. Use the four (4) holes in the flange as a template to mark
the position where the holes should be drilled to secure
the mount.
Figure 7.2 Mark Flange Holes
3. Drill the four (4) holes in the installation location, screws
not supplied, use a minimum screw length of 10 mm
(.39 in.).
4. Drill a fifth hole (maximum of 20 mm [.79 in.]) in the
center of the four-hole pattern used to mount the flange.
Use this hole to feed the wires through the mount.
5. Fit the flange (supplied) to the pipe.
Note: Select the pipe length of 200 mm (7.9 in.), 300 mm
(11.8 in.), or combine the two (2) pipes with the integral
coupler for 505 mm (20 in.).
Outdoor Installation: Apply the following O-rings (supplied
with the AutoDome Junior Outdoor Camera) to the
locations specified below:
CAUTION!
All wires for installation applications must be routed through a
grounded conduit.