Filter
Top Products
AutoDome Junior HD Configuring the AutoDome Junior HD | en 169
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
Telnet support. The unit will then no longer be accessible using
the Telnet protocol.
Interface mode ETH
If necessary, select the Ethernet link type for the ETH interface.
Depending on the unit connected, it may be necessary to select
a special operation type.
Network MSS (Byte)
You can set the maximum segment size for the IP packet's user
data. This gives you the option to adjust the size of the data
packets to the network environment and to optimize data
transmission. Please comply with the MTU value of 1,514 bytes
in UDP mode.
iSCSI MSS (Byte)
You can specify a higher MSS value for a connection to the
iSCSI system than for the other data traffic via the network. The
potential value depends on the network structure. A higher
value is only useful if the iSCSI system is located in the same
subnet as the AutoDome 800 Series.
Enable DynDNS
DynDNS.org is a DNS hosting service that stores IP addresses in
a database ready for use. It allows you to select the AutoDome
800 Series via the Internet using a host name, without having to
know the current IP address of the unit. You can enable this
service here. To do this, you must have an account with
DynDNS.org and you must have registered the required host
name for the unit on that site.
Host name
Enter the host name registered on DynDNS.org for the
AutoDome 800 Series here.
NOTICE!
Information about the service, registration process and
available host names can be found at DynDNS.org.