Filter
Top Products
152 en | Configuring the AutoDome Junior HD AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
Video transmission
If the unit is operated behind a firewall, TCP (HTTP port)
should be selected as the transfer protocol. For use in a local
network, select UDP.
Stream
Select the stream for transmission in case of an alarm.
Remote port
Depending on the network configuration, select a browser port
here. The ports for HTTPS connections will be available only if
the On option is selected in the SSL encryption parameter.
Video output
If you know which unit is being used as the receiver, you can
select the analog video output to which the signal should be
switched. If the destination unit is unknown, it is advisable to
select the First available option. In this case, the image is
placed on the first free video output. This is an output on which
there is no signal. The connected monitor only displays images
when an alarm is triggered. If you select a particular video
output and a split image is set for this output on the receiver,
you can also select from Decoder the decoder in the receiver
that is to be used to display the alarm image.
NOTICE!
If you enter the destination IP address 0.0.0.0 for destination
10, this address will no longer be used for the tenth attempt at
automatic connection in the event of an alarm. The parameter is
then used only to save the general password.
CAUTION!
Please note that in some circumstances, a larger bandwidth
must be available on the network for additional video images in
the event of an alarm, in case Multicast operation is not
possible. To enable Multicast operation, select the UDP option
for the Video transmission parameter here and on the Network
page (see Page 165).