Filter
Top Products
AutoDome Junior HD Preparing the Wiring | en 79
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
8.2.1 Power Connections to Indoor/Outdoor Cameras
Figure 8.1 Power Cable
To connect the power to indoor models:
1. Locate the cable assembly with a three (3) pin mating
connector on one end and the red and black flying leads on
the other end.
2. Connect one lead of the 24 VAC power source to the black
wire.
3. Connect the other lead of the 24 VAC power source to the
red wire.
4. Connect the green earth ground cable to a suitable
grounded conduit.
WARNING!
The indoor or outdoor AutoDome Junior HD camera can accept
power from the 24 VAC power input or from the Ethernet input.
Ensure that the camera receives power from only one source.
Refer to Section 8.3 Ethernet Connection, page 81, for more
information about connecting Power over Ethernet.
Ref. # Wire Color
124 VAC Red
2 24 VAC Black
3 User-supplied Power Supply n/a
NOTICE!
The camera unit accepts 24 VAC, 1.2 A power only. Do not
connect 120 V or 230 V to this camera.