Filter
Top Products
172 en | Configuring the AutoDome Junior HD AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
UPnP
You can activate the universal plug and play function (UPnP).
When activated the camera reacts on requests from the
network and will be registered automatically as a new network
device on the inquiring computers. The access to the camera is
then possible via the Windows file explorer, and without
knowledge of the camera’s IP address.
This function should not be used in large installations due to
the large number of registration notifications.
TCP Metadata Input
The device can receive data from an external TCP sender, for
example an ATM or POS device, and store it as metadata.
Select the port for TCP communication. Select Off to deactivate
the TCP metadata function.
Sender IP Address
Enter the IP address of the TCP metadata sender here.
NTCIP
Specifies a set of rules and protocols for organizing, describing
and exchanging transportation management information
between transportation management applications and
transportation equipment such that they interoperate with each
other.
Select a port for NTCIP and the Address from the appropriate
drop-down lists.
12.48 Multicast
In addition to a 1:1 connection between an encoder and a
single receiver (unicast), the AutoDome Junior HD can enable
multiple receivers to receive the video signal from an encoder
simultaneously. The device either duplicates the data stream
NOTICE!
In order to use the UPnP function on a computer with Windows
XP or Windows Vista, the Universal Plug and Play Device Host
and the SSDP Discovery services must be activated.