Filter
Top Products
AutoDome Junior HD Configuring the AutoDome Junior HD | en 159
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
Scene too bright
Activate this function if tampering associated with exposure to
extreme light (for instance, shining a flashlight directly on the
lens) should trigger an alarm. The average brightness of the
scene provides a basis for recognition.
Scene too dark
Activate this function if tampering associated with covering the
lens (for instance, by spraying paint on it) should trigger an
alarm. The average brightness of the scene provides a basis for
recognition.
Scene too noisy
Activate this function if tampering associated with EMC
interference (noisy scene as the result of a strong interference
signal in the vicinity of the video lines), as an example, should
trigger an alarm.
Select Area
You can select the image areas in the reference image that are
to be monitored. The video image is subdivided into 858 square
fields. Each of these fields can be activated or deactivated
individually.
1. Click Select Area to configure the sensor fields. A new
window will open.
2. If necessary, click Clear All first to clear the current
selection (fields marked yellow).
3. Left-click the fields to be activated. Activated fields are
marked yellow.
4. If necessary, click Select All to select the entire video
frame for monitoring.
5. Right-click any fields you wish to deactivate.
6. Click OK to save the configuration.
7. Click the close button X in the window title bar to close
the window without saving the changes.
NOTICE!
Select only those areas for reference monitoring in which no
movement takes place and that are always evenly lit, as false
alarms could otherwise be triggered.