Filter
Top Products
AutoDome Junior HD Installing a Recessed Mount | en 57
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
2. Drill or cut a 200 mm hole with a tolerance of 2.2 mm
(7.9 in. ± 1/8).
3. Optional: if installing the AutoDome Junior to a suspended
ceiling tile or any other surface where additional support is
required, the VJR-A3-SP mounting kit is recommended
(supplied separately).
4. Ensure that the gasket is attached to the retaining ring. If
the gasket and the retaining ring are separate:
a. Locate the flat side of the gasket and the recessed
side of the retaining ring.
b. Thread the flat side of the gasket (item 1, below) onto
the recessed side of the retaining ring (item 2). The
illustration below shows a cross-section of the gasket
on the retaining ring.
CAUTION!
You must ensure that the gasket is attached to the retaining
ring as shown above to ensure an environmentally tight seal.