Filter
Top Products
AutoDome Junior HD Configuring the AutoDome Junior HD | en 131
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
12.19 Privacy Masks
Privacy Masking is used to block out a specific area of a scene
from being viewed. Masks can be configured as a gray area with
four corners. You may define a total of 24 privacy masks.
To add a privacy mask to a scene:
1. Navigate to the scene in which you want to apply a privacy
mask.
a. Click the View Control link.
b. Use the PTZ controls to view the scene.
2. Select the privacy mask number to apply to the scene.
The preview window displays a gray rectangle in the scene.
3. Click the Enable check box to activate the privacy mask.
The privacy mask in the preview window changes to
orange to indicate that the mask will appear in the video
streams on the Livepage.
4. Select a mask color from the Pattern list box.
5. Place the cursor inside the privacy mask area in the
preview window; then click and drag to move the privacy
mask.
6. Place the cursor on a corner or on a side of the mask
rectangle; then click and drag to expand or shrink the
privacy mask area.
NOTICE!
– The AutoDome disables the Privacy Mask feature if the
orientation of the camera is set to Inverted. Refer to
Section 12.16 Installer Menu, page 123, for orientation
settings.
– You cannot apply a privacy mask 70° (tilt direction) below
the horizon.
NOTICE!
Draw the mask 10% larger than the object to ensure that the
mask completely covers the object as the AutoDome zooms in
and out.