Filter
Top Products
38 en | Installing a Wall Mount AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
5.1.3 Preparing the Wall Mount for an Outdoor
Installation
The following instructions detail the surface preparations and
the steps to install the Wall Mount for an outdoor application.
1. Determine a secure location for the wall mount (supplied
separately).
Figure 5.4 Wall Mount Dimensions
2. Use the four (4) holes at the end of the Wall Mount as a
template to mark the position where the holes should be
drilled to secure the mount.
3. Drill the four (4) holes in the installation location, screws
not supplied. Use a minimum screw length of 10 mm
(.39 in.).
4. Drill a fifth hole (maximum of 20 mm) in the center of the
four-hole pattern used to mount the arm.
5. Ensure that the gasket is attached to the retaining ring. If
the gasket and the retaining ring are separate:
NOTICE!
The fasteners and mounting surface must be capable of
supporting a maximum load of 11.33 kg (25 pounds).
220.4
(8.68)
333.0
(13.11)
366.0
(14.1)
291.0
(11.46)