Filter
Top Products
AutoDome Junior HD Configuring the AutoDome Junior HD | en 157
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
Select Area (MOTION+ only)
The areas of the image to be monitored by the motion detector
can be selected. The video image is subdivided into 858 square
fields. Each of these fields can be activated or deactivated
individually. If you wish to exclude particular regions of the
camera's field of view from monitoring due to continuous
movement (by a tree in the wind, etc.), the relevant fields can
be deactivated.
1. Click Select Area to configure the sensor fields. A new
window will open.
2. If necessary, click Clear All first to clear the current
selection (fields marked yellow).
3. Left-click the fields to be activated. Activated fields are
marked yellow.
4. If necessary, click Select All to select the entire video
frame for monitoring.
5. Right-click any fields you wish to deactivate.
6. Click OK to save the configuration.
7. Click the close button X in the window title bar to close
the window without saving the changes.
Tamper detection
You can reveal the tampering of cameras and video cables by
means of various options. Run a series of tests at different
times of the day and night to ensure that the video sensor is
operating as intended.
NOTICE!
The options for tamper detection can only be set for fixed
cameras. Dome cameras or other motorized cameras cannot be
protected in this manner as the movement of the camera itself
causes changes in the video image that are too great.