Filter
Top Products
24 en | Installing a Surface Mount AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
4.1.1 Additional Tools Required
– Appropriate straight slot screwdrivers
– No. 2 Phillips screwdriver
– Appropriate tool for cutting a hole in drywall or ceiling tile
(if applicable)
– 4 in. x 4 in. Junction box with 90 mm (3.54 in.) mount
holes (indoor installation)
– One (1) ground
– T-10 Torx wrench
– Four (4) M4 or #10 pan head screws of an appropriate
length to screw deep enough into the surface, required for
an outdoor installation
– VEZ-A2-JW or VEZ-A2-JC Surface Mount Adapter, required
for an outdoor installation
– AutoDome Junior Outdoor Camera, required for an
outdoor installation
4.1.2 Preparing the Surface Mount for an Indoor
Installation
The following instructions detail the preparation necessary to
prepare the surface and the steps to install a Surface Mount.
1. Determine a secure location for the surface mount dome.
Figure 4.1 Indoor Surface Mount Dimensions
ø
175.0
(6.89)
166.9
(6.57)
R64.2
(2.53)