Filter
Top Products
AutoDome Junior HD Configuring the AutoDome Junior HD | en 127
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
Maximum data rate
This maximum data rate is not exceeded under any
circumstances. Depending on the video quality settings for the
I- and P-frames, this fact can result in individual images being
skipped.
The value entered here must be at least 10% higher than the
value entered in the Target data rate field. If the value entered
here is too low, it will automatically be adjusted.
Video resolution
Here you can select the desired resolution for the video image.
The following resolutions are available:
– SD/240p (WQVGA)
432×240 pixels
– SD/480p (WVGA)
854 x 480 pixels
– 720p
1280×720 pixels
– 1080p
1920×1080 pixels
Encoding Interval
The figure selected here determines the interval at which
images are encoded and transmitted. The image rate in ips
(images per second) is displayed next to the text field.
Use the slide bar to select a frame rate from 30.00 ips to 1 ips.
Expert Settings
Use the expert settings to adapt the I-frame quality and the P-
frame quality to specific requirements, if necessary. The setting
is based on the H.264 quantization parameter (QP).
GOP Structure
Select the structure you require for the Group of Pictures here.
Depending on whether you place greater priority on having the
lowest possible delay (IP frames only) or using as little
bandwidth possible, you can choose between IP, IBP, and IBBP.