Filter
Top Products
AutoDome Junior HD Installing a Surface Mount | en 29
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
8. Determine the side of the Surface Mount Adapter in which
the external wires are to be routed and remove the plug
from the knockout.
9. Apply a 1/2-inch (15-mm) NPS fitting to the chosen
knockout. Ensure a water-tight fitting to maintain the IP
Environmental Protection Rating for the unit.
10. Attach the Surface Mount Adapter to the surface using four
(4) user-supplied M4 or #10 pan head screws (screws not
supplied). Use a minimum screw length of 10 mm (.39 in.).
Note: For an outdoor installation ensure that the four (4)
3.97 mm I.D. by Ø1.78 mm O-rings are threaded onto the
four (4) M4 or #10 user-supplied pan head screws. Refer to
step 5.
Figure 4.7 Attach surface mount to ceiling
1 M3 – .5 x 6 Phillips flat head machine screws
(supplied with AutoDome Junior Outdoor Camera)
2 Retaining ring with gasket
(supplied with AutoDome Junior Outdoor Camera)
3 O-ring, 3.97 mm I.D. by Ø1.78 mm
(supplied with AutoDome Junior Outdoor Camera)
4 User-supplied M4 or #10 pan head screws