Filter
Top Products
54 en | Installing a Recessed Mount AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
10. Ensure unit is centered.
11. Align trim ring so the four alignment posts (item 1, below)
align with the recesses in the camera housing (item 2) and
so the two safety screws align with the off center holes
(item 3) on the locking clamps.
Note: The two (2) sets of raised stand-off tabs (item 4) on
each side of the trim ring align with the locking clamps.
Figure 6.9 Align Trim Ring
12. Snap trim ring into place. Ensure snaps are secure by
attempting to lightly turn unit. Note: Unit should not turn.
13. Use a T-10 Torx wrench to secure the trim ring’s two (2)
safety locking screws to the mounting bracket.
NOTICE!
The recessed mounting bracket is provided with an additional
safety tether point. To prevent injury, attach a safety wire from
a secure anchor point above the ceiling to this tether point.
1 Alignment Tabs (four)
2 Align tabs to the recessed areas on the housing
3 Align safety locking screws to these connections
4 Stand-off Tabs (two)