Filter
Top Products
74 en | Installing a Pipe Mount AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
7.1.3 Installing the Camera to the Mounting Plate
To install the camera to a ceiling mount using the supplied
mounting plate, do the following:
1. Route wires on side of mounting plate with crescent
shaped cut-out.
2. Attach grounding wire from unit to mounting cap.
3. Attach user supplied ground to junction box.
4. Connect the mating connectors with the flying leads to the
user supplied wiring (see the Section 8 Preparing the
Wiring, page 77 for wiring information).
5. Unlock the single safety locking screw on the base of the
unit using the user-supplied Allen wrench.
Figure 7.7 Unlock Safety Locking Screw
6. Plug the matching connectors from the camera into the
mating connectors from the ceiling.
7. Align wires on side of mounting plate with crescent shaped
cut-out.
8. Attach the camera to the mounting plate by inserting the
vertical tab on the plate (item 1, below) into the recessed
slot on the top of the camera dome (Item 3) to the right of
the safety locking screw (item 2).