Filter
Top Products
92 en | Using the IP Interface AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
11.4 Configuring the AutoDome Junior HD
Camera
To operate the camera in your network you must assign it a
valid network IP address. The default IP address is 192.168.0.1,
but you may have to change this address if it conflicts with
another device on your network. Refer to Section 12.3 Basic
Mode: Network, page 111 for more information.
To properly configure the camera for your network, you need
the following information:
– Unit IP address: An identifier for the camera on a TCP/IP
network. For example, 140.10.2.110 is a valid syntax for an
IP address.
– Subnet mask: A mask used to determine what subnet an IP
address belongs to.
– Gateway IP address: A node on a network that serves as an
entrance to another network.
– Port: An endpoint to a logical connection in TCP/IP and
UDP networks. The port number identifies the use of the
port for use through a firewall connection.
1 AutoDome Junior HD
2 IP Connection
3 Network Switch
4Computer
NOTICE!
You can also use the Bosch Configuration Manager utility to
configure the network settings for an AutoDome Junior IP or HD
camera. Go to www.boschsecurity.com to download the
Configuration Manager software and Operating Manual.
NOTICE!
Ensure that the network parameters of your cameras are
available before you begin configuration.