Filter
Top Products
AutoDome Junior HD Configuring the AutoDome Junior HD | en 119
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
1. First check whether the correct time zone is selected. If it
is not correct, select the appropriate time zone for the
system, and click the Set button.
2. Click the Details button. A new window will open and you
will see the empty table.
3. Select the region or the city that is closest to the system's
location from the list field below the table.
4. Click the Generate button to generate data from the
database in the unit and enter it into the table.
5. Make changes by clicking an entry in the table. The entry is
selected.
6. Clicking the Delete button will remove the entry from the
table.
7. Select other values from the list fields below the table to
change the entry. Changes are made immediately.
8. If there are empty lines at the bottom of the table, for
example after deletions, you can add new data by marking
the row and selecting required values from the list fields.
9. Now click the OK button to save and activate the table.
Time server IP address
The AutoDome Junior HD can receive the time signal from a
time server using various time server protocols, and then use it
to set the internal clock. The unit polls the time signal
automatically once every minute.
Enter the IP address of a time server here.
Time server type
Select the protocol that is supported by the selected time
server. Preferably, you should select the SNTP server as the
protocol. This supports a high level of accuracy and is required
for special applications and subsequent function extensions.
Select Time server for a time server that works with the
protocol RFC 868.