Filter
Top Products
AutoDome Junior HD Configuring the AutoDome Junior HD | en 153
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
Decoder
Select a decoder of the receiver to display the alarm image. The
decoder selected has an impact on the position of the image in
a split screen. For example, you can specify via a VIP XD that
the upper-right quadrant should be used to display the alarm
image by selecting decoder 2.
SSL encryption
The data for the connection, for example the password, can be
securely transmitted with SSL encryption. If you have selected
the On option, only encrypted ports are offered in the Remote
port parameter.
You can activate and configure encryption of the media data
(video and metadata) on the Encryption page (see
Section 12.47 Advanced, Page 170).
Auto-connect
Select the On option to automatically re-establish a connection
to one of the previously specified IP addresses after each
reboot, after a connection breakdown or after a network failure.
NOTICE!
Refer to the destination unit documentation concerning image
display options and available video outputs.
NOTICE!
Please note that the SSL encryption must be activated and
configured at both ends of a connection. This requires the
appropriate certificates to be uploaded onto the AutoDome
Junior HD.
NOTICE!
In the default setting, Stream 2 is transmitted for automatic
connections. Bear this fact in mind when assigning the profile
(see Section 12.17 Encoder Profile, page 124).