Filter
Top Products
AutoDome Junior HD Configuring the AutoDome Junior HD | en 173
Bosch Security Systems, Inc. Installation Manual F.01U.275.803 | 6.0 | 2012.11
itself and then distributes it to multiple receivers (Multi-
unicast) or it sends a single data stream to the network, where
the data stream is simultaneously distributed to multiple
receivers in a defined group (Multicast). You can enter a
dedicated multicast address and port for each stream. You can
switch between the streams by clicking the appropriate tabs.
A special IP address (class D address) must be configured for
multicast operation in a multicast-enabled network.
The network must support group IP addresses and the Internet
Group Management Protocol (IGMP V2). The address range is
from 225.0.0.0 to 239.255.255.255.
The multicast address can be the same for multiple streams.
However, it will be necessary to use a different port in each
case so that multiple data streams are not sent simultaneously
using the same port and multicast address.
Enable
To enable simultaneous data reception on several receivers you
need to activate the multicast function. To do this, check the
box. You can then enter the multicast address.
Multicast Address
Enter a valid multicast address for each stream to be operated
in multicast mode (duplication of the data streams in the
network).
With the setting 0.0.0.0 the encoder for the relevant stream
operates in multi-unicast mode (copying of data streams in the
NOTICE!
Multicast operation requires a multicast-enabled network that
uses the UDP and the Internet Group Management IGMP
protocols. Other group management protocols are not
supported. The TCP protocol does not support multicast
connections.
NOTICE!
The settings must be made individually for each stream.