Filter
Top Products
170 en | Configuring the AutoDome Junior HD AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
User name
Enter the user name you registered at DynDNS.org here.
Password
Enter the password you registered at DynDNS.org here.
Force registration now
You can force the registration by transferring the IP address to
the DynDNS server. Entries that change frequently are not
provided in the Domain Name System. It is a good idea to force
the registration when you are setting up the device for the first
time. Only use this function when necessary and no more than
once a day, to avoid the possibility of being blocked by the
service provider. To transfer the IP address of the AutoDome
800 Series, click the Register button.
Status
The status of the DynDNS function is displayed here for
information purposes. You cannot change any of these settings.
12.47 Advanced
The settings on this page are used to implement advanced
settings for the network.
Some changes only take effect after the unit is rebooted. In this
case, the Set button changes to Set and Reboot.
1. Make the desired changes.
2. Click the Set and Reboot button. The AutoDome Junior HD
is rebooted and the changed settings are activated.
SNMP
The AutoDome Junior HD supports the SNMP V2 (Simple
Network Management Protocol) for managing and monitoring
network components, and can send SNMP messages (traps) to
IP addresses. The unit supports SNMP MIB II in the unified
code. If you wish to send SNMP traps, enter the IP addresses of
one or two required target devices here.
If you select On for the SNMP parameter and do not enter an
SNMP host address, the AutoDome Junior HD does not send