Filter
Top Products
164 en | Configuring the AutoDome Junior HD AutoDome Junior HD
F.01U.275.803 | 6.0 | 2012.11 Installation Manual Bosch Security Systems, Inc.
Name
You can enter a name for each alarm input, which is then
displayed below the icon for the alarm input on the Livepage if
configured correctly (see Section 12.14 Livepage Functions,
page 121). Furthermore, in the Forensic Search program, you
can use the name as a filter option for quick search through the
recordings.
12.44 Relay
You can configure the switching behavior of the relay outputs.
For each relay, you can specify an open switch relay (normally
closed contact) or a closed switch relay (normally open
contact).
You can also specify whether an output should operate as a
bistable or monostable relay. In bistable mode, the triggered
state of the relay is maintained. In monostable mode, you can
set the time after which the relay will return to the idle state.
You can select different events that automatically activate an
output. It is possible, for example, to turn on a floodlight by
triggering a motion alarm and then turning the light off again
when the alarm has stopped.
Idle State
Select Open if you want the relay to operate as an NO contact,
or select Closed if the relay is to operate as an NC contact.
CAUTION!
Do not use any special characters, for example &, in the name.
Special characters are not supported by the system's internal
recording management and may therefore result in the Player or
Archive Player programs being unable to play back the
recording.