Filter
Top Products
108
SONICWALL SONICOS ENHANCED 2.5 ADMINISTRATOR’S GUIDE
C
HAPTER
17:
Setting Up the DHCP Server
The DHCP Server Configuration window is displayed. In the Dynamic Ranges table, the Range
Start, Range End, and Interface information is displayed.
Configuring DHCP Server for Dynamic Ranges
To configure DHCP server for dynamic IP address ranges, follow these instructions:
1
In the Dynamic page, click Add. The Dynamic Ranges Configuration window is displayed.
General
1
In the General page, make sure the Enable this DHCP Range is checked, if you want to enable
this range.
2
Select the interface from the Interface menu. The IP addresses are in the same private subnet as
the selected interface.
9
Tip: To select an interface from the Interface menu, it must first be fully configured and it must be of
the Zone type, LAN or DMZ.
3
Use the default IP address range entries for the interface in the Range Start and Range End
fields or type in your own IP address range.
4
Type the number of minutes an IP address is used before it is issued another IP address in the
Lease Time (minutes) field. 1440 minutes (24 hours) is the default value.
5
Select the gateway from the Gateway Preferences menu. The interface IP address is the default
value, but you can select Other and type a different IP address for the gateway.