Filter
Top Products
Chapter 9 Routing Protocol
ZyWALL (ZLD) CLI Reference Guide
108
9.2.1 RIP Commands
This table lists the commands for RIP.
9.2.2 General OSPF Commands
This table lists the commands for general OSPF configuration.
Table 49 router Commands: RIP
COMMAND DESCRIPTION
router rip Enters sub-command mode.
[no] network interface_name Enables RIP on the specified Ethernet interface. The no
command disables RIP on the specified interface.
[no] redistribute {static | ospf} Enables redistribution of routing information learned from
the specified source. The
no command disables
redistribution from the specified source.
redistribute {static | ospf} metric <0..16> Sets the metric when redistributing routing information
learned from the specified source.
[no] version <1..2> Sets the default RIP version for all interfaces with RIP
enabled. If the interface RIP version is blank, the interface
uses the default version. This is not available in the GUI.
The
no command sets the default RIP version to 2.
[no] passive-interface interface_name Sets the direction to “In-Only” for the specified interface.
The
no command sets the direction to bi-directional.
[no] authentication mode {md5 | text} Sets the authentication mode for RIP. The no command
sets the authentication mode to “none”.
[no] authentication string authkey Sets the password for text authentication. The
no
command clears the password.
authentication key <1..255> key-string authkey Sets the MD5 ID and password for MD5 authentication.
no authentication key Clears the MD5 ID and password.
[no] outonly-interface interface_name Sets the direction to “Out-Only” for the specified interface.
The
no command sets the direction to “BiDir”.
Table 50 router Commands: General OSPF Configuration
COMMAND DESCRIPTION
router ospf Enters sub-command mode.
[no] redistribute {static | rip} Enables redistribution of routing information learned from the
specified non-OSPF source. The
no command disables redistribution
from the specified non-OSPF source.
[no] redistribute {static | rip} metric-
type <1..2> metric <0..16777214>
Sets the metric for routing information learned from the specified
non-OSPF source. The
no command clears the metric.
[no] passive-interface interface_name Sets the direction to “In-Only” for the specified interface. The no
command sets the direction to “BiDir”.
[no] router-id IP Sets the 32-bit ID (in IP address format) of the ZyWALL. The
no
command resets it to “default”, or the highest available IP address.