Filter
Top Products
Chapter 25 Device HA
ZyWALL (ZLD) CLI Reference Guide
224
[no] device-ha ap-mode interface_name
manage-ip ip subnet_mask
Sets the management IP address for an interface.
[no] device-ha ap-mode interface_name
activate
Has device HA monitor the status of an interface’s connection.
[no] device-ha ap-mode master sync
authentication password password
This is for a master ZyWALL. It specifies the password to require from
synchronizing backup ZyWALLs. Every router in the virtual router must use
the same password. The
no command sets the password setting to blank
(which means no backups can synchronize with this master).
password: Use 4-63 alphanumeric characters, underscores (_), dashes (-),
and
#%^*={}:,.~ characters.
[no] device-ha ap-mode backup sync
authentication password password
Sets the password the backup ZyWALL uses when synchronizing with the
master. The
no command sets the password setting to blank (which means
this backup ZyWALL cannot synchronize with the master).
password: Use 4-63 alphanumeric characters, underscores (_), dashes (-),
and
#%^*={}:,.~ characters.
[no] device-ha ap-mode backup sync
auto
Turns on automatic synchronization according to the interval you specify in
device-ha ap-mode backup sync interval. The first synchronization
begins after the specified interval (not immediately).
[no] device-ha ap-mode backup sync
interval <1..1440>
When you use automatic synchronization, this sets how often (in minutes)
the ZyWALL synchronizes with the master.
[no] device-ha ap-mode backup sync
from master_address port port
Sets the address of the master ZyWALL with which this backup ZyWALL is
to synchronize.
master_address: The master ZyWALL’s IP address or fully-qualified domain
name (FQDN).
port: The master ZyWALL’s FTP port number.
device-ha ap-mode backup sync now Synchronize now.
show device-ha ap-mode interfaces Displays the device HA AP mode interface settings and status.
show device-ha ap-mode next-sync-time Displays the next time and date (in hh:mm yyyy-mm-dd format) the
ZyWALL will synchronize with the master.
show device-ha ap-mode status Displays the ZyWALL’s key device HA settings.
show device-ha ap-mode master sync Displays the master ZyWALL’s synchronization settings.
show device-ha ap-mode backup sync Displays the backup ZyWALL’s synchronization settings.
show device-ha ap-mode backup sync
status
Displays the backup ZyWALL’s current synchronization status.
show device-ha ap-mode backup sync
summary
Displays the backup ZyWALL’s synchronization settings.
show device-ha ap-mode forwarding-port
interface_name
If you apply Device HA on a bridge interface on a backup ZyWALL, you can
use this command to see which port in the bridge interface is chosen to
receive VRRP packets used to monitor if the master ZyWALL goes down.
interface_name: This is a bridge interface, For example, brx.
Table 126 device-ha ap-mode Commands (continued)
COMMAND DESCRIPTION