Filter
Top Products
Chapter 6 Interfaces
ZyWALL (ZLD) CLI Reference Guide
78
6.6.1 Cellular Status
The following table describes the different kinds of cellular connection status on the ZyWALL.
budget percentage {ptime|pdata} <0..99> Sets a percentage (0~99) of time budget (ptime) or data (pdata)
limit. When the specified limit is exceeded, the ZyWALL takes the
action configured using the budget {log-percentage|log-
percentage-alert} command.
budget {log-percentage|log-percentage-
alert} [recursive <1..65535>]
Sets to have the ZyWALL create a log (log-percentage) or an alert
log (log-percentage-alert) when the set percentage of time budget
or data limit is exceeded. You can configure the percentage using the
budget percentage command.
You can also set how often (from 1 to 65535 minutes) to send the log
or alert.
no budget log-percentage Sets the ZyWALL to not create a log when the set percentage of time
budget or data limit is exceeded. You can configure the percentage
using the budget percentage command.
connectivity {nail-up | dial-on-demand} Sets the connection to be always on or only when there is traffic.
[no] local-address <ip> Sets (or clears) the cellular interface’s local (own) IP address.
mtu <576..1492> Sets the Maximum Transmission Unit in bytes.
[no] pin <pin code> Sets (or clears) the PIN code for the cellular device’s 3G card. Use 1-
4 alphanumeric characters, underscores(
_), or dashes (-).
[no] remote-address <ip> Sets (or clears) the IP address of the cellular interface’s peer (like a
gateway or PPPoE server).
interface cellular budget-auto-save
<5..1440>
Sets how often (in minutes) the ZyWALL saves time and data usage
records for a connection using the 3G card.
show interface cellular [corresponding-
slot|device-status|support-device]
Shows the status of the specified cellular interface.
show interface cellular corresponding-slot Shows which cellular interface is on which slot and whether which
cellular interface has been configured.
show interface cellular device-status Displays the installed SIM card and 3G card status.
show interface cellular support-device Displays all 3G card models the ZyWALL can support.
show interface cellular budget-auto-save Displays how often (in minutes) the ZyWALL records time and data
usage of your 3G budgets.
show interface cellular status Displays the traffic statistics and connection status for your cellular
interfaces. See Section 6.6.1 on page 78 for all possible cellular status
descriptions.
show interface interface_name [budget] Displays the budget control settings for the specified cellular
interface.
show interface interface_name device status Displays the 3G card and SIM card information for the specified
cellular interface.
show interface interface_name device
profile
Displays the 3G connection profile settings of the specified cellular
interface.
Table 27 Cellular Interface Commands (continued)
COMMAND DESCRIPTION
Table 28 Cellular Status
STATUS DESCRIPTION
No device no 3G device is connected to the ZyWALL.
No service no 3G network is available in the area; you cannot connect to the Internet.