Filter
Top Products
Chapter 41 Reports and Reboot
ZyWALL (ZLD) CLI Reference Guide
324
41.1.2 Report Command Examples
The following commands start collecting data, display the traffic reports, and stop collecting data.
41.1.3 Session Commands
This table lists the commands to display the current sessions for debugging or statistical analysis.
41.1.4 Packet Size Statistics Commands
Using the packet size statistics to view packet size distribution may aid you in troubleshooting
network performance. In particular, a large number of small packets can drastically reduce
throughput. This table lists the commands to enable and disable packet size statistics data
collection and display the setting status and statistics.
Router# configure terminal
Router(config)# show report ge1 ip
No. IP Address User Amount Direction
===================================================================
1 192.168.1.4 admin 1273(bytes) Outgoing
2 192.168.1.4 admin 711(bytes) Incoming
Router(config)# show report ge1 service
No. Port Service Amount Direction
====================================================================
1 21 ftp 1273(bytes) Outgoing
2 21 ftp 711(bytes) Incoming
Router(config)# show report ge1 url
No. Hit URL
=====================================================================
1 1 140.114.79.60
Router(config)# show report status
Report status: on
Collection period: 0 days 0 hours 0 minutes 18 seconds
Table 195 Session Commands
COMMAND DESCRIPTION
show conn [user
{username|any|unknown}] [service
{service-name|any|unknown}]
[source {ip|any}] [destination
{ip|any}] [begin <1..128000>]
[end <1..128000>]
Displays information about the selected sessions or about all sessions. You can
look at all the active sessions or filter the information by user name, service
object, source IP, destination IP, or session number(s).
any means all users, services and IP addresses respectively.
unknow means unknown users and services respectively.
show conn ip-traffic destination Displays information about traffic session sorted by the destination.
show conn ip-traffic source Displays information about traffic session sorted by the source.
show conn status Displays the number of active sessions.
Table 196 Packet Size Statistics Commands
COMMAND DESCRIPTION
[no] report packet size statistics Enables or disables packet size statistics data collection.
show report packet size statistics status Shows whether packet size statistics data collection is enabled or
disabled.