Filter
Top Products
Chapter 39 File Manager
ZyWALL (ZLD) CLI Reference Guide
302
• When the ZyWALL reboots, if the startup-config.conf file passes the error check, the ZyWALL
keeps a copy of the startup-config.conf file as the lastgood.conf configuration file for you as a
back up file. If you upload and apply a configuration file with an error, you can apply
lastgood.conf to return to a valid configuration.
39.2.4 Configuration File Flow at Restart
If there is not a startup-config.conf when you restart the ZyWALL (whether through a
management interface or by physically turning the power off and back on), the ZyWALL uses the
system-default.conf configuration file with the ZyWALL’s default settings.
If there is a startup-config.conf, the ZyWALL checks it for errors and applies it. If there are no
errors, the ZyWALL uses it and copies it to the lastgood.conf configuration file. If there is an error,
the ZyWALL generates a log and copies the startup-config.conf configuration file to the startup-
config-bad.conf configuration file and tries the existing lastgood.conf configuration file. If there
isn’t a lastgood.conf configuration file or it also has an error, the ZyWALL applies the system-
default.conf configuration file.
You can change the way the startup-config.conf file is applied. Include the
setenv-startup
stop-on-error off
command. The ZyWALL ignores any errors in the startup-config.conf file
and applies all of the valid commands. The ZyWALL still generates a log for any errors.
39.3 File Manager Commands Input Values
The following table explains the values you can input with the file manager commands.
Table 184 File Manager Command Input Values
LABEL DESCRIPTION
file_name The name of a file. Use up to 25 characters (including a-zA-Z0-9;‘~!@#$%^&()_+[]{}’,.=-).