Filter
Top Products
ZyWALL (ZLD) CLI Reference Guide 41
CHAPTER 4
Status
This chapter explains some commands you can use to display information about the ZyWALL’s
current operational state.
Here are examples of the commands that display the CPU and disk utilization.
Table 7 Status Show Commands
COMMAND DESCRIPTION
show boot status Displays details about the ZyWALL’s startup state.
show comport status Displays whether the console and auxiliary ports are on or off.
show cpu status Displays the CPU utilization.
show disk Displays the disk utilization.
show extension-slot Displays the status of the extension card slot and USB ports and the names of devices connected
to them.
show fan-speed Displays the current fan speed.
show led status Displays the status of each LED on the ZyWALL.
show mac Displays the ZyWALL’s MAC address.
show mem status Displays what percentage of the ZyWALL’s memory is currently being used.
show ram-size Displays the size of the ZyWALL’s on-board RAM.
show redundant-
power status
Displays the status of the ZyWALL’s power modules. The ZyWALL has two power modules. It can
continue operating on a single power module if one fails.
show serial-number Displays the serial number of this ZyWALL.
show socket listen Displays the ZyWALL’s listening ports
show socket open Displays the ports that are open on the ZyWALL.
show system uptime Displays how long the ZyWALL has been running since it last restarted or was turned on.
show version Displays the ZyWALL’s model, firmware and build information.
Router(config)# show cpu status
CPU utilization: 0 %
CPU utilization for 1 min: 0 %
CPU utilization for 5 min: 0 %
Router(config)# show disk
; <cr> |
Router(config)# show disk
No. Disk Size(MB) Usage
===========================================================================
1 image 67 83%
2 onboard flash 163 15%