Filter
Top Products
Chapter 16 Firewall
ZyWALL (ZLD) CLI Reference Guide
140
session-limit append Enters the session-limit sub-command mode to add a session-limit rule
to the end of the session-limit rule list.
session-limit delete rule_number Removes a session-limit rule.
session-limit flush Removes all session-limit rules.
session-limit insert rule_number Enters the session-limit sub-command mode to add a session-limit rule
before the specified rule number.
session-limit move rule_number to
rule_number
Moves a session-limit to the number that you specified.
show session-limit Shows the session-limit configuration.
show session-limit begin rule_number end
rule_number
Shows the settings for a range of session-limit rules.
show session-limit rule_number Shows the session-limit rule’s settings.
show session-limit status Shows the general session-limit settings.
[no] session-limit6 activate Turns the IPv6 session-limit feature on or off.
session-limit6 limit <0..8192> Sets the default number of concurrent NAT/firewall IPv6 sessions per
host.
session-limit6 rule_number Enters the IPv6 session-limit sub-command mode to set a session-limit
rule.
[no] activate Enables the IPv6 session-limit rule. The no command disables the
session limit rule.
[no] address address6_object Sets the IPv6 source IP address. The
no command sets this to any,
which
means all IP addresses.
[no] description description Sets a descriptive name (up to 64 printable ASCII characters) for a
session-limit rule. The no command removes the descriptive name from
the rule.
exit Quits the sub-command mode.
[no] limit <0..8192> Sets the limit for the number of concurrent NAT/firewall IPv6 sessions
this rule’s users or addresses can have. 0 means any.
[no] user user_name Sets an IPv6 session-limit rule for the specified user. The
no command
resets the user name to the default (any). any means all users.
session-limit6 append Enters the IPv6 session-limit sub-command mode to add a session-limit
rule to the end of the session-limit rule list.
session-limit6 delete rule_number Removes an IPv6 session-limit rule.
session-limit6 flush Removes all IPv6 session-limit rules.
session-limit6 insert rule_number Enters the IPv6 session-limit sub-command mode to add a session-limit
rule before the specified rule number.
session-limit6 move rule_number to
rule_number
Moves an IPv6 session-limit to the number that you specified.
show session-limit6 Shows the IPv6 session-limit configuration.
show session-limit6 begin rule_number end
rule_number
Shows the settings for a range of IPv6 session-limit rules.
show session-limit6 rule_number Shows the IPv6 session-limit rule’s settings.
show session-limit6 status Shows the general IPv6 session-limit settings.
Table 69 Command Summary: Session Limit (continued)
COMMAND DESCRIPTION