Filter
Top Products
Chapter 40 Logs
ZyWALL (ZLD) CLI Reference Guide
319
40.1.2.1 System Log Command Examples
The following command displays the current status of the system log.
40.1.3 Debug Log Commands
This table lists the commands for the debug log settings.
Router# configure terminal
Router(config)# show logging status system-log
512 events logged
suppression active : yes
suppression interval: 10
category settings :
content-filter : normal , forward-web-sites : no ,
blocked-web-sites : normal , user : normal ,
myZyXEL.com : normal , zysh : normal ,
idp : normal , app-patrol : normal ,
ike : normal , ipsec : normal ,
firewall : normal , sessions-limit : normal ,
policy-route : normal , built-in-service : normal ,
system : normal , connectivity-check: normal ,
device-ha : normal , routing-protocol : normal ,
nat : normal , pki : normal ,
interface : normal , interface-statistics: no ,
account : normal , port-grouping : normal ,
force-auth : normal , l2tp-over-ipsec : normal ,
anti-virus : normal , white-list : normal ,
black-list : normal , ssl-vpn : normal ,
cnm : normal , traffic-log : no ,
file-manage : normal , dial-in : normal ,
adp : normal , default : all ,
Table 189 logging Commands: Debug Log Settings
COMMAND DESCRIPTION
show logging debug status Displays the current settings for the debug log.
show logging debug entries [priority pri]
[category module_name] [srcip ip] [srcip6
ipv6_addr] [dstip ip] [dstip6 ipv6_addr]
[service service_name] [srciface interface_name]
[dstiface interface_name] [protocol protocol]
[begin <1..512> end <1..512>] [keyword keyword]
Displays the specified entries in the system log.
pri: alert | crit | debug | emerg | error | info | notice | warn
keyword: You can use alphanumeric and
()+/:=?!*#@$_%-
characters, and it can be up to 63 characters long. This searches
the message, source, destination, and notes fields.
show logging debug entries field field [begin
<1..1024> end <1..1024>]
Displays the specified field in the debug log.
field: time | msg | src | dst | note | pri | cat | all
[no] logging debug suppression Enables log consolidation in the debug log. The
no command
disables log consolidation in the debug log.
[no] logging debug suppression interval
<10..600>
Sets the log consolidation interval for the debug log. The
no
command sets the interval to ten.
clear logging debug buffer Clears the debug log.